Close
JOES Roll Bar Mounts
These roll bar mounts fit JOES Aluminum Bottle Clamps (23030, 23050, 23065, 23080)
Close
JOES Clamp Reducer
Step down your JOES Clamp from 1-3/4″ to 1-5/8″, 1-1/2″ or 1-1/4″ with an aluminum JOES Reducer. Comes in handy
Close
JOES Slug Type A-Plate
Get your race car through the corners faster by changing your front roll center. Our rigid steel A-Plate easily welds
Close
JOES Canister Mounts
No more tie straps, bailing wire or bubble gum needed to hold your shock canisters or remote filters! JOES Canister
Close
JOES Aluminum Bottle Clamp
Multiple mount sizes ensure you get the best fit for your needs. Works with nitrous, CO2, fresh air bottles and
Close
JOES Clamp
Weld a JOES Clamp to any aluminum component that you want to bolt to the chassis. Tighten two allen screws
Close
Allstar 1/8 inch Flat Tabs, 4pk, 1/4 inch Hole
Mild steel flat tabs have a straight edge and can be welded parallel to round tubing, square tubing or flat
Close
JOES Vent Tank
If you are blowing oil out of your transmission or rear end vent line, you need a JOES baffled Vent
Close
JOES 1″ Panhard Mount
JOES Panhard Mount is lightweight but strong enough to withstand extreme racing conditions. You can quickly adjust your roll center
Close
JOES Dry Sump Breather Tank
JOES Dry Sump Breather tank is designed to allow venting of your dry sump tank while catching any oil that
Close
Allstar Aluminum Hood Pin Kit
Hood Pin kits come with 2 ea of Black Anodized Aluminum Pins, Scuff Plates, Torsion Clips and 4 Jam Nuts.
Close
JOES Jr Sprint Upper Tank Mount
Designed to mount your 2 gallon Jaz fuel tank to your Jr Sprint chassis. Made out of 6061-T6 Aluminum.